Bob Smith Industries MAXI-CURE POCKET Extra Thick CA (3/4oz)

Bob Smith Industries MAXI-CURE POCKET Extra Thick CA w/Pin in Cap (3/4oz)

Pocket CAs are available in 3/4 & 4 oz. sizes and feature a top that has a pin built into the cap that covers the nozzle. This pin seals the bottle so that if it is tipped over, the bottle will not leak. This makes the Pocket CAs ideal for keeping in your tool or field box, just like our IC-Gel. This pin also helps prevent the clogging of the nozzle. One disadvantage that the new Pocket CA top has is the bluntness of the nozzle. This makes it more difficult to apply small amounts of the CA, especially in tight places. BSI's #304 extender tip can be used on the nozzle for finer applications. The Pocket CAs are available with BSI's Insta-Cure, Insta-Cure+, Maxi-Cure and Super-Gold+.

About:

Maxi-Cure extra thick CA is the best CA for most plastics, including GE's Lexan MAXI-CURE is the best choice for plastic model assembly. When used with INSTA-SET, it works better than any putty for modifying or filling voids. It can be carved with a knife or razor blade and sanded and feathered to form a finish indistinguishable from plastic. MAXI-CURE bonds fiberglass, hardwood, metal and rubber better than any other hobby adhesive. For gluing to the inside, clothtextured surface of fiberglass, scrape the area to be bonded with a razor blade or coarse sandpaper before using MAXI-CURE or any other adhesive. It also is best for bonding the tires for R/C cars.

MAXI-CURE has proven to be very popular in the archery business for the fletching of vanes onto aluminum and carbon arrow shafts. Along with being the strongest, MAXI-CURE is usually the least expensive option for this application.

Works Best On:

• Soft Wood
• Hard Wood
• Glass & Metal
• Fiberglass
• Ceramics
• Hard Plastics
• Rubber
• Laminating
• Reinforcing

Works Good On:

• Balsa Wood
• Water-Resistant

Directions:

Unscrew top from nozzle. For finer applications, use the extender tip. Apply Maxi-Cure CA to one side of the parts being joined, then hold them tightly together for 10-20 seconds. For larger bonding areas, apply serpentine beads of the CA with enough spacing to allow for the spreading of the adhesive. Insta-Set accelerator can be sprayed to cure the CA that oozes from joints. Full strength is reached in three hours. Wipe the nozzle clean before replacing screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220º F. Soak extender tip in acetone for cleaning.